how "tight" should the black plastic on the bottom of the frame be?

Plaats reactie
abuchris
Runner-up
Runner-up
Denmark
Berichten: 15
Lid geworden op: 04 okt 2019, 08:02
Locatie: Denmark

I just took a small fall today, was barely moving, but slipped on leaves.
And tonight I noticed that the black plastic cover that is on the bottom of the bike (from the horn near the pedals, to the front of the bike), seems "loose" in the middle of it. .I can almost pry a finger in there, by pulling it a bit.
Is this normal? I can't remember if it was always like this. It seems very tight at both ends, but not in the middle.
Gebruikersavatar
Stromeur
Admin | Forum Supporter
Admin | Forum Supporter
Netherlands
Berichten: 22831
Lid geworden op: 15 mei 2017, 20:18
Locatie: Friesland
Merk SP: Stromer ST3 PINION SE

Not normal. Seems to happen more often with the ST3. Contact your dealer and ask to have it replaced under warranty.
Stromer ST1 X 2017 - Stromer ST2 S 2018 - Klever X ALPHA 45 2021 - Stromer ST3 PINON 2023
abuchris
Runner-up
Runner-up
Denmark
Berichten: 15
Lid geworden op: 04 okt 2019, 08:02
Locatie: Denmark

thank you
mrstrom

They replaced mine under waranty, the new type is more rigid and fits nicely.
Plaats reactie